Posted by mark on May 03, 2001 at 17:00:14: via: or 213.122.231.193
In Reply to: You could put a voltmeter switch across the switch posted by NickD on May 03, 2001 at 16:50:02:
sorry to keep on Nick but, if the low pressure switch was faulty would i not get a very high pressure reading? Or does that switch read high and low pressures? I did notice that when the air con was switched on after the engine was run, i had high pressure in low side. "obviously". As the pressure came down to 30 the compressor cut in "i.e the low side switch noticed low pressure and on came the compressor" so why would it cut it out straight away?
As you can see im trying to get my mind around this fault.
Sorry to say, i just dont understand... Am i missing something??
Please walk me through this,,, and again thank you very much,, and yes i know im a pain!!!