Posted by Chick on October 14, 19101 at 08:24:55: via: spider-mtc-ti044.proxy.aol.com or 64.12.101.169
In Reply to: Re: GM A/C Clutch Nut size posted by BSmith on October 13, 19101 at 21:50:05:
A clutch puller is all that is needed if there is no nut.. Hard to do if not enough space. The hole where you thought a nut may be should be threaded. The hub puller screws in and then the center "screw"goes againt the shaft and as you turn the nut, the outside hub comes off. The installer works by screwing on the center shaft,and then turning the bigger nut pushes it on...There are several clutch tools for the different compressors. Check out acsource.com.. He doesn't list them seperately, but if you e-mail them, they can sell you the specific puller/installer for your compressor...Hope this helps..